Improve voltage measurement

Apply PWM_VOLT_PIN without reboot.
Check if the voltage pin can be used with ADC when setting up.
Set voltage to NAN, when it's unknown (including pyflix).
pyflix@0.15.
Don't send BATTERY_STATUS when voltage is unknown.
Add dummy voltage to the simulator.

flix/mavlink.ino

@@ -46,7 +46,7 @@ void sendMavlink() {
 		float remaining = constrain(mapf(voltage, 3.4, 4.2, 0, 1), 0, 1);
 		mavlink_msg_battery_status_pack(mavlinkSysId, MAV_COMP_ID_AUTOPILOT1, &msg, 0, MAV_BATTERY_FUNCTION_ALL,
 			MAV_BATTERY_TYPE_LIPO, INT16_MAX, voltages, -1, -1, -1, remaining * 100, 0, MAV_BATTERY_CHARGE_STATE_OK, voltagesExt, 0, 0);
-		sendMessage(&msg);
+		if (valid(voltage)) sendMessage(&msg);
 	}
 
 	if (telemetryFast && mavlinkConnected) {

flix/parameters.ino

@@ -117,7 +117,7 @@ Parameter parameters[] = {
 	{"MAV_RATE_SLOW", &telemetrySlow.rate},
 	{"MAV_RATE_FAST", &telemetryFast.rate},
 	// power
-	{"PWR_VOLT_PIN", &voltagePin},
+	{"PWR_VOLT_PIN", &voltagePin, setupPower},
 	{"PWR_VOLT_SCALE", &voltageScale},
 	{"PWR_VOLT_LPF_A", &voltageFilter.alpha},
 	// safety

flix/power.ino

@@ -8,14 +8,14 @@
 #include "lpf.h"
 #include "util.h"
 
-float voltage;
+float voltage = NAN;
 LowPassFilter<float> voltageFilter(0.2);
 int voltagePin = -1;
 float voltageScale = 2;
 
 void setupPower() {
-	// Disable reset on low voltage
-	REG_CLR_BIT(RTC_CNTL_BROWN_OUT_REG, RTC_CNTL_BROWN_OUT_ENA);
+	REG_CLR_BIT(RTC_CNTL_BROWN_OUT_REG, RTC_CNTL_BROWN_OUT_ENA); // disable reset on low voltage
+	if (digitalPinToAnalogChannel(voltagePin) == -1) voltagePin = -1; // test ADC pin
 }
 
 void readVoltage() {