Use MAVLink LOG_REQUEST_DATA and LOG_DATA for download log instead of console.
Make Wi-Fi download default way of downloading the log.
Make `log` command only print the header and `log dump` dump the log.
Support SET_ATTITUDE_TARGET, SET_ACTUATOR_CONTROL_TARGET in mavlink.
ACTUATOR_OUTPUT_STATUS is changed ACTUATOR_CONTROL_TARGET to match used message for setting motor outputs.
Add support for changing mode from mavlink.
Support automatic flights in pyflix.
Arm and disarm with gestures only: left stick right/down for arming, left/down for disarming.
Remove arming switch as it complicates arming gestures logic.
Remove MAV_CTRL_SCALE parameter as it complicates arming gestures logic, advise to decrease TILT_MAX when controlling with a smartphone.
Put some minimal thrust to motors to indicate armed state.
Rename build article to usage article, add flight instructions.
Add interpretControls function to convert pilot commands and mode into control targets and make control functions independent from the mode.
Add ratesExtra target for rates feed-forward; remove yawMode.
Rename controlRate to controlRates to reflect rates variable name.
Remove USER mode.
Implement channels mapping calibration.
Store mapping in parameters.
Get rid of `controls` array and store control inputs in `controlRoll`, `controlPitch`, ... variables.
Move `channels` variable to rc.ino, channels are not involved when controled using mavlink.
'Neutral' values are renamed to 'zero' - more precise naming.
`controlsTime` is renamed to `controlTime`.
Use unsigned values for channels.
Make channel values in simulation more alike to real world: unsigned values in range [1000, 2000].
Send RC_CHANNELS_RAW instead of RC_CHANNELS_SCALED via mavlink
Don't send channels data via mavlink if rc is not used
Fix disconnecting from qgc while pausing in the simulation.
Consider total delay time in micros() in simulation to increase t while delaying.
Simplify and get rid of ARDUINO macro check.
1000 Hz is too low frequency considering the update loop for motors signal is also 1000 Hz.
Decrease resolution as it's required to set larger pwm frequencies.
This change should vastly improve control jitter and remove audible motors noise.
